Planos de marqueteria pdf

  • admin
  • Comments Off on Planos de marqueteria pdf

Hola Pedro, he recibido los planos hoy, todo correcto. Tengo ganas de ponerme a trabajar con ellos. Planos de marqueteria pdf he escaneado cuidadosamente y los he transformado en ficheros pdf.

Estos planos fueron publicados hace mucho tiempo en la revista Hobbies. 1739 por Boris Radovskiy de los EEUU. Hobbies 1739 por Boris Radovskiy de los EEUU. Hobbies 1698 por Russel Stout de los Estados Unidos. Hobbies 1732 por Pietro de la provincia de Cremona, Italia. Hobbies 1717 por Russel Stout de los Estados Unidos. Hobbies 2187 por Carlo Saladini de Italia.

Hobbies 1726 por Renato Zanoni desde Italia. Hobbies 1714 por Renato Zanoni desde Italia. Hobbies 2185 por German Loginov desde Rusia. Hobbies 1732 por Loretta Vodziak desde Estados Unidos. He operated two large flat sweeps to steer the boat, as can be seen in the model. These sweeps pivoted through the projecting sides, long handles being provided to reach up to where the navigator stood.

There was one mainsail and one forward one fitted on a bowsprit which passes over the bow, and fits at an angle into the deck. The construction of the actual model is after the same lines as our previous ones. Next we can fit on the deck and its position is obvious by the cut fore and aft which fit over the upright keel pieces. On top of this deck a further block is glued each side of the keel piece both at the bow and the stern, as can be seen in the details herewith.

The outer edge of these blocks must be symmetrical with the deck and the hull. One end is tapered down wedge shaped so it may fit and be glued between the outer hull and the main body itself. Notice the long strip which also has to be glued to the hull. Of course, if you prefer, you can sink it slightly into the deck itself to glue there and to the bow platform. On the deck itself is a cabin made up of two ends, two sides and the roof.